Understanding the WatchMon - Tools - Firmware

Caution  Make sure that external peripheral systems will be ok when the system reboots. The system will go offline and reboot, if there is a critical contactor that must remain energised additional measures must be made by you to prevent the disruption of power.

  Step 1 - Go to the Tools Menu

Step 2 - Press the Firmware updater button.

Step 3 - Choose the device

Step 4 - If you have your WatchMon connected it will auto fill in the target image.  Run the upgrade process.

A separate console program will open and start uploading to Teensy

Step 5 - Monitor that the program complete 100% successfully.

If  SUCCESS close and start Toolkit.

Notes

• If any problems occur repeat after powering down and up the WatchMon (both USB and power should be removed.
• Each version of firmware has a relevant version of software for the toolkit. When changing the firmware make sure you also do the necessary upgrade/retrograde to the "Toolkit" software.
• If device does not respond press BOOT/PROG on WatchMon to manually enter Program Mode.