How to connect to WatchMon via WiFi access point

Steps to remotely connect to the BMS via wifi router / access point. Caution the system will only be in display mode to ensure a safe connection. To make changes to the system will require the technician connect via USB.

Step 1 - Navigate to system connection selector and click

Step 2 - Navigate to Network tab 

Step 3 - Select SystemID from available option (either click or enter number)

Step 4 - Close connection dialogue once system is connected and Active

Step 5 - Normal responding screens

Troubleshooting

If there is a software/ firmware mismatch the following will be displayed. There is a firmware upgrade process documented below.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us