SOFTWARE: Upgrading to Preview

PLEASE NOTE: WATCHMON TOOLKIT REQUIRES A FULL VERSION OF WINDOWS SOFTWARE

Step 1: Choose update

Step 2 – Select the Device Firmware you would like to update (eg. WatchMonPlus - WM5).

Step 3 - Press Verify if it didn't run Automatically

Step 4: Go to the option tab and choose Preview to get the preview release

When chosen you will get the warning so should only proceed if directed to by Batrium

Step 5: Go back to Progressive and press Download

Step 6 Press Download to get the setup installer

Step 7: Backup your existing configuration files

Step 8 This is where you start if you have been given an msi file or downloaded from the list of releases. click I Accept and press Install

Step 9`: Program should install, you may get a message depending on your security to allow it to run.

If you have WatchMon Toolkit open you will get the message below. You should close the toolkit and retry

Step 10: When completed you will be ready to go and can click finish and launch WatchMon Toolkit.

Step 11 From inside WatchMon Toolkit run the firmware updater.